Matrix H7xe Owner's Manual download pdf (Page 6)

Exercise Bikes

DIY

www.gymtechservice.com

• Screwdriver or Allen Key set Required

(depending on equipment)

• Digital Multimeter

• New Battery

• Rivet Removal Tool if StairMaster Product

Easy Diculty

If you have any questions on our DIY

section or would like to have the maintenance

performed for you, please feel free to contact

us.

We are always happy to help!

E-Mail: [email protected]

Toll Free: 866-GYM-TECH

Checking & ReplacingChecking & Replacing

Exercise Bike BatteriesExercise Bike Batteries

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Refer to your owner’s manual on the placement of the battery.

If you need help locating your battery, contact us and we will

gladly help you locate your battery.

→

Send an email to our technicians!

[email protected]

Remove the covers from the unit where the battery is located.

This almost all of the time means you will be taking at least one

full side of covers o of the bike. Some exercise bikes may have

screws that must be removed from the bottom of the bike as

well. If this is the case,

with another person helping you

, care-

fully put the bike down on its side.

In some cases, you must remove a pedal or both pedals to

remove the covers. You will need the proper pedal wrench for

this.

This tool is one of our specials this season.

Using your digital multi-meter in DC mode, put the Red Lead

from the meter on the positive (+) corresponding tab that is

located on the battery and put the Black Lead from the

meter on the negative (-) tab. Make sure the tips of the

leads have a good contact. If you have a 6 Volt battery

and the multi-meter reads less than 6 Volts (around 6 Volts)

then it should be replaced. If your battery is a 12 Volt, then it

should be at or around 12 Volts.

If the battery reads proper voltage and your unit is still not

working, your equipment problem lies with something else

At that time you can either request additional technical support or

schedule a service call to diagnose the issue by emailing

[email protected]

If the battery is low or has completely lost its charge than remove the wires

attached to the battery.

Detach the battery from the unit, some units have their batteries secured with screws. In most locales, you must dispose of

batteries in a certain way. Make sure you research battery disposal procedures in your area.

Install the new battery and attach the wires to the positive and negative terminals as they were installed before you

removed the old battery.

Test the unit. If the unit is now functional, then install the covers and the repair has been completed.

Unit is still not working? Test the battery with your multi-meter to make sure that it still has sucient power. Sometimes,

even new batteries that have not been used can go bad. Make sure the wires are connected to the terminals properly.

After you are sure the battery has power and the wiring is attached properly, test the unit again.

Still Didn’t Help? Then you can contact

Gym Tech Fitness Service with the

information below.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Matrix H7xe Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Spin bikes Matrix H7xe