Matrix U7xe Service Manual download pdf (Page 81)

10.5 TV PROGRAMMING INSTRUCTIONS (US) - CONTINUED

CHAPTER 10: BIKE SPECIFICATIONS AND ASSEMBLY GUIDE

Auto Scan (continued):

8. If the channels are not coming in clearly after a channel scan (or if only some channels come in), follow Steps 4-7 to enter the Installation .

Use the CHANNEL UP or DOWN keys to change the TV System to match the club's incoming frequency (Figure G), then re-run Auto Scan.

10. If the channels are coming in clearly, press the HOME key to return to normal function (Figure H). If some channels are still not coming

in, are blurry, or are not scanning, follow the procedure below for adding / deleting a single channel. If no channels are coming in, see the

troubleshooting in Chapter 8.

Adding or Deleting a Single Channel - At times the Channel Scan can pick up channels that do not have a strong enough signal to

come in clearly or will fail to pick up channels that do come in clearly. Use the following procedure to manually add or delete a channel.

1. Follow Steps 1-4 in the Auto Scan instructions to access the TV Menu.

2. Use the CHANNEL UP or DOWN keys to scroll to Channel Management the Menu. Then press the ENTER key to enter the Channel

Management sub-menu.

3. Use the CHANNEL UP or DOWN keys to scroll to Hide / Show (Figure I). Then press the ENTER key to enter the Hide / Show sub-menu.

4. The Hide / Show sub-menu will show a list of channels available (Figure J). Channels with a check mark are scanned in and should show

up during normal TV usage.

5. To remove or add any channel, simply scroll to the channel using the CHANNEL UP or DOWN keys, and then press ENTER to add or delete

a check mark (which adds or deletes the channel).

6. Once the desired channels are scanned in, press HOME to return to normal operation.

FIGURE JFIGURE I

FIGURE HFIGURE G

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 87

No comments

Matrix U7xe Service Manual Page 81