Matrix U7xe Service Manual download pdf (Page 85)

11.1 SOFTWARE UPGRADE INSTRUCTIONS

CHAPTER 11: SOFTWARE UPGRADE GUIDE

FIGURE A FIGURE B

FIGURE C FIGURE D

* An AC power cord is required to update software in the field. Plug in the unit prior to beginning the update procedure.

** All plug ins must be removed prior to updating software (for example, no IPod can be connected). Do not use the console while an

update is in process.

*** If VA is installed on the console, wait until the Virtual Active icon on the standard display picture turns red prior to updating the

software.

1) Five files should be present on the USB drive. These are: DrummuDeploy.cab, NK, IO_XXX, updateLMM.confige, and Extract_CE.

2) Turn on the power to the bike, wait until the standard display picture has been come up (Figure A).

2) Enter Manager Mode by pressing ENTER, 1, 0, 0, 1, ENTER on the lower keypad.

3) Record the Accumulated Mileage, Accumulated Time, and Serial Number. NOTE: The information can be lost during the update procedure

and should be recorded so that the information can be entered into the newly updated console.

4) Press the HOME key to return to the standard display picture.

5) Wait until the Virtual Active icon turns RED. Insert the USB Drive into the USB port in the console (Figure B).

6) After a few seconds, the bike will auto run the upgrade processing. The achieved percentage of the scheduled process will be displayed in

the bottom right corner of the display (Figure C).

7) When the update is complete, the display will ask you to remove the USB drive (Figure D). Once the USB drive is removed, turn off the bike

and wait 10 seconds, then turn the bike back on.

8) Enter Service Mode by pressing ENTER, 3, 0, 0, 1, ENTER on the lower keypad and check that the Machine Type is correctly set for Upright

Bike and that the Service On Boot setting is NO. If the Machine Type is not correct, press ENTER, 3, 0, 0, 2, ENTER. This will do a software

parameter reset. Then change the Machine Type. Once the Machine Type is changed cycle unit and console power. Press the HOME key to

return to the standard display picture if the Machine Type is correct.

9) Also enter the values recorded in Step 3 in Service Mode (if needed).

9) Enter Manager Mode by pressing ENTER, 1, 0, 0, 1, ENTER on the lower keypad. Press SOFTWARE VERSIONS to verify that the new

software version is shown on the screen. Re-load software if any problems are seen.

10) Test the bike for function as outlined in Section 9.19.

1 2 ... 80 81 82 83 84 85 86 87

No comments

Matrix U7xe Service Manual Page 85