Matrix A7xe Service Manual download pdf (Page 60)

9.13 INCLINE MOTOR REPLACEMENT

CHAPTER 9: PART REPLACEMENT GUIDE

1) Turn off the power and disconnect the cord from the machine.

2) Remove the front disks as outlined in Section 9.1.

3) Complete Steps 6-8 and 10 from Section 9.2 to remove the cupholder and top shrouds from the unit (the main side shrouds do not need to be

removed).

4) Disconnect the incline motor ground wire from the frame and disconnect the incline motor power wire (Figures A & B). If unsure if the incline

motor is the issue, plug in the new incline motor at this time to see if it is energized. If it is not, the issue is likely with the LCB.

5) Remove the spring clip to separate the incline motor from the frame (Figure C).

6) Remove the incline motor by loosening the pivot bolts on each side (Figure D - NOTE: Figure D shows the unit with the shrouds removed for

clarity). NOTE:Priortolooseningthepivotbolts,securetheinclinemotorasitcanfalloncethepivotboltsareloosened.

FIGURE A FIGURE B

FIGURE DFIGURE C

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

No comments

Matrix A7xe Service Manual Page 60