Matrix A7xe Service Manual download pdf (Page 71)

9.22 TESTING THE ASCENT TRAINER

ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND

PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST

THE MACHINE:

1) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER) and input the serial number of the console. Also set the Machine Type (See Section 7.2)

and Keypad (See Section 7.3) and verify that the Date and Time are correct (See Section 7.5). NOTE: The console and unit power must be

reset for some changes to go into affect. Cycle the power switch and press and hold the CHANNEL UP and CHANNEL DOWN keys for 3-5

seconds to reset the console power.

2) Enter Manager Mode (ENTER, 1, 0, 0, 1, ENTER) and turn on or off Asset Management or Virtual Active depending on whether the club has

these functions. NOTE: The console and unit power must be reset for some changes to go into affect. Cycle the power switch and press and

hold the CHANNEL UP and CHANNEL DOWN keys for 3-5 seconds to reset the console power.

3) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate

exercising. While moving listen for any odd noises or squeaks.

4) After stopping movement, press the green GO key and begin using the machine.

5) Grasp the hand grips to check for proper heart rate response.

6) Press the LEVEL UP and DOWN keys on the console to make sure resistance is fully functional.

7) Press the ELEVATION UP and DOWN keys (fully incline and decline the machine) to make sure the incline motor function is fully operational.

8) If the Ascent Trainer has had an incline motor replaced, or if this is the initial installation, calibrate the lift motor (see Section 3.5).

CHAPTER 9: PART REPLACEMENT GUIDE

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 91 92

No comments

Matrix A7xe Service Manual Page 71