Matrix A7xe Service Manual download pdf (Page 88)

10.5 TV PROGRAMMING INSTRUCTIONS - CONTINUED

AutoScan(continued):

9. If the channels are not coming in clearly after a channel scan (or if only some channels come in), follow Steps 4-7 to enter the Auto Scan

sub-menu. Use the VOLUME UP or DOWN keys to change the Cable System to match the club's incoming frequency (Figure G), then re-run

Auto Scan.

10. If the channels are coming in clearly, press the HOME key to return to normal function (Figure H). If some channels are still not coming

in, are blurry, or are not scanning, follow the procedure below for adding / deleting a single channel. If no channels are coming in, see the

troubleshooting in Chapter 2.

AddingorDeletingaSingleChannel-At times the Channel Scan can pick up channels that do not have a strong enough signal to

come in clearly or will fail to pick up channels that do come in clearly. Use the following procedure to manually add or delete a channel.

1. Follow Steps 1-4 in the Auto Scan instructions to access the TV Menu.

2. Use the VOLUME UP or DOWN keys to scroll to Channel on the top right of the Menu.

3. Use the CHANNEL UP or DOWN keys to scroll to Show / Hide (Figure I). Then use the VOLUME UP or DOWN keys to enter the Show /

Hide sub-menu.

4. The Show / Hide sub-menu will show a list of channels available (Figure J). Channels with a check mark are scanned in and should show

up during normal TV usage.

5. To remove or add any channel, simply scroll to the channel using the CHANNEL UP or DOWN keys, and then press ENTER to add or delete

a check mark (which adds or deletes the channel).

6. Once the desired channels are scanned in, press HOME to return to normal operation.

FIGURE JFIGURE I

FIGURE HFIGURE G

CHAPTER 10: ASCENT TRAINER SPECIFICATIONS AND ASSEMBLY GUIDE

1 2 ... 83 84 85 86 87 88 89 90 91 92

No comments

Matrix A7xe Service Manual Page 88