Matrix U7xe Service Manual download pdf (Page 70)

9.20 TESTING THE BIKE

ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND

PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO SETUP

AND TEST THE MACHINE:

1) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER) and input the serial number of the console. Also set the Machine Type (See Section 7.2)

and Keypad (See Section 7.3) and verify that the Date and Time are correct (See Section 7.5). NOTE: If a setting has been changed, the

unit and console power should be reset. Cycle the power switch, and press and hold the CHANNEL UP and CHANNEL DOWN keys for 3-5

seconds to reset the console power.

2) Enter Manager Mode (ENTER, 1, 0, 0, 1, ENTER) and turn on or off Asset Management or Virtual Active depending on whether the club has

these functions. NOTE: If a setting has been changed, the unit and console power should be reset. Cycle the power switch, and press and

hold the CHANNEL UP and CHANNEL DOWN keys for 3-5 seconds to reset the console power. Enter into Virtual Active and test.

3) Program the TV channels (see Section 10.5).

4) Without hitting start or entering any program modes, sit on the bike and hold the handlebars while pedaling to simulate exercising. While

moving, listen for any odd noises or squeaks.

5) After stopping movement, press the green GO key and begin pedaling.

6) Grasp the hand grips to check for proper heart rate response.

7) Press the level up and down buttons on the console and hand grips to make sure resistance is fully functional.

8) If everything functions properly, stop pedaling and the unit will reset to normal operation within 30 seconds.

CHAPTER 9: PART REPLACEMENT GUIDE

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 86 87

No comments

Matrix U7xe Service Manual Page 70