Matrix U7xe Service Manual download pdf (Page 62)

9.15 DRIVE BELT REPLACEMENT

1) Remove the side covers as outlined in Section 9.9 (Figure A).

2) Using a hook or loop of wire, remove the spring from the frame (Figure B). The tensioner should now pivot away from the drive belt.

3) Remove the drive belt (Figure C).

4) Use a straight edge to make sure that the pulley and generator pulley are in a straight line (Figure D). If the belt is not on line, try to adjust

the generator location.

5) Reverse Steps 1-4 to install a new drive belt. NOTE: Be sure to reattach the tension spring. Rotate the pulley to make sure that the motion

is smooth and that there is no wobbling to one side.

CHAPTER 9: PART REPLACEMENT GUIDE

FIGURE A FIGURE B

FIGURE C FIGURE D

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 86 87

No comments

Matrix U7xe Service Manual Page 62